Previously I loaded psx-pi-smbshare on a Raspberry Pi 2 Model B board. Everything was working good. I then bought a Raspberry Pi 3 Model B+ board. I set up everything the same. A fresh SanDisk Ultra 16GB card. Image burned with Balena Etcher Portable 1.7.9. On the Pi 3 there is no display when connected to TV and OPL can't connect to SMB. The card just isn't booting.
I tried the card I had been using on the Pi 3. Isn't booting.
I tried the newly burned card on the Pi 2. Works just like 1st...
psx-pi-smbshare works on Pi 2 but no boot on Pi 3
I tried the card I had been using on the Pi 3. Isn't booting.
I tried the newly burned card on the Pi 2. Works just like 1st...
psx-pi-smbshare works on Pi 2 but no boot on Pi 3