I recently installed a Matrix Infinity 1.93 clone into a DESR 7500.
The diagram that is floating around for these is actually wrong, Y, A and B need to move over by 1 pin.
After getting everything wired up and reassembling everything, the disc drive spins for a second then just stops.
This is for both CDs and DVDs. If I boot Ulaunchelf it will report Stop Disc shortly after inserting a disc.
My best guess at the moment is that it's the ribbon cable for the sanyo laser. the blue tab came...
DESR 7500 Disc spins briefly then stops
The diagram that is floating around for these is actually wrong, Y, A and B need to move over by 1 pin.
After getting everything wired up and reassembling everything, the disc drive spins for a second then just stops.
This is for both CDs and DVDs. If I boot Ulaunchelf it will report Stop Disc shortly after inserting a disc.
My best guess at the moment is that it's the ribbon cable for the sanyo laser. the blue tab came...
DESR 7500 Disc spins briefly then stops
